How to cut single color LED Strip Lights and use Quick Connector Products

LED Strip Lights are such a versatile product do to the fact that they can easily be cut on the given cut lines and connected at any point between the copper dots on the LED Strip Lights, cut lengths vary between products. See the below tutorial for a complete guide on cutting LED Strip Lights and using quick connectors for connection.


1.) Find the Cut Line
When cutting LED Strip Light it is very important to cut only on the given cut line between the copper dots. Cutting through or before the copper dots will result in no electrical conductivity to the following section.
Cut Line

2.) Cut the LED Strip Light
Use a pair of sharp scissors to cut the LED Strip Light directly down the given cut line.
Cut LED

3.) Determine the Top of Quick Connector
Quick Connectors can only be used when the top is facing upwards. It is important to determine the polarity on the LED Strip Light as well as sometimes if connecting from the opposite end wire colors can be crossed and cause confusion.

*BE SURE YOU ARE USING THE CORRECT SIZE QUICK CONNECTOR AS THEY VARY IN WIDTH DEPENDING ON THE LED STRIP YOU ARE USING.*
QC Top


4.) Pull out Black Plastic
Gently pull out the black plastic piece about 1/8 of an inch. Be sure not to pull too hard and damage the quick connector.
Pull Plastic

5.) Peel Back 3M Adhesive
Peel back the tape of the 3M adhesive approximately 1/4 of an inch.
Peel Adhesive

6.) Insert Strip Light into Quick Connector
Insert Strip Light into connector, check the wire polarity (red wire to positive) copper dots should not be visible.

*QUICK CONNECTORS CAN BE USED ON EITHER END OF RIBBON. IF USED ON OPPOSITE END BE CERTAIN OF THE POLARITY AND NOTE THE WIRE COLOR REVERSAL.*
Insert


7.) Secure Quick Connector
With connector between your 4 fingers, squeeze the black piece closed.
Secure LED

8.) Test Connection
This is what a proper installation will look like, now test by connecting lead wires to a power source.